Clearing Snow and Ice Without Hurting Yourself, Your Concrete or Your Plants
A typical Massachusetts winter means dozens of rounds of shoveling, salting and chipping. Doing it the right way keeps people from slipping, keeps you from straining your back or heart, and keeps walkways, steps and garden beds from being damaged by the cure.
Shovel smarter
- Start while the snow is still falling in a big storm. Two or three light passes are easier than one heavy one.
- Use an ergonomic shovel with a bent handle, and push snow to the side rather than lifting and throwing it.
- When you must lift, bend at the knees, keep the load small and close to your body, and turn your feet instead of twisting your back.
- Wet, heavy snow can weigh many times more than light powder. Take frequent breaks and stay hydrated.
- Shoveling is strenuous exercise. People with heart conditions or who are not usually active should talk to their doctor first, and stop immediately at any chest pain, shortness of breath or dizziness.
Choosing an ice melt
All ice melts work by lowering the freezing point of water. They differ in how cold they keep working and how hard they are on concrete, metal and plants. Effective temperatures below are approximate and vary by product.
- Rock salt (sodium chloride): inexpensive and effective down to roughly the mid-teens °F. Hard on plants, lawns, pets’ paws and metal, and can damage weak or young concrete.
- Calcium chloride: works at much colder temperatures and acts quickly. Use sparingly; overuse can still harm plants and surfaces.
- Magnesium chloride: works in cold weather and is generally considered somewhat gentler on plants and concrete than rock salt.
- Products labeled pet-safe or plant-safe are usually blends that use less chloride. They cost more and may work more slowly.
- Sand or grit: does not melt anything but adds traction instantly. Useful on very cold days and near plants. Sweep it up in spring so it does not wash into drains.
Protecting concrete, pavers and stone
- Avoid deicing salts on concrete that is less than a year old. It has not fully cured and is more prone to surface flaking (scaling).
- Sealing concrete steps and walkways in the fall with a penetrating sealer helps resist water and salt damage.
- Shovel first, then apply ice melt. It is meant to break the bond between ice and pavement, not to melt a full layer of snow.
- Do not chip ice with a metal tool on concrete, brick or stone. Let ice melt loosen it, then scrape gently.
- Many natural stones and older brick are sensitive to salt. Check with the installer or use sand on those surfaces.
Protecting lawns and plants
- Do not pile salty snow on garden beds, shrubs or the lawn edge, and keep it away from the base of trees.
- Use burlap screens for shrubs along a road or driveway that get salt spray.
- In spring, water salt-affected areas deeply to flush the salt down through the soil.
Where to put the snow
Pile snow downhill from walkways and the house so meltwater does not run back across the path and refreeze overnight. Keep piles away from the foundation, window wells, dryer and furnace vents, fire hydrants, and the end of the driveway where they block sightlines for cars pulling out. Avoid burying gas meters; use a broom to clear them gently.
Keep it safe all season
- Fix downspouts that discharge across walkways or driveways; they create a sheet of ice every night.
- Make sure exterior steps have sturdy handrails and good lighting.
- Keep a container of ice melt or sand by each door you use.
- Check with your town about clearing the public sidewalk in front of your house; many communities have rules about how soon after a storm it must be done.
Need a hand? See our seasonal upkeep services or request a free estimate.
This guide is general information for homeowners, written from our experience maintaining homes in Essex County, MA. Every house is different, so have a qualified professional look at anything structural, electrical, plumbing or safety-related. Browse all guides.
Related guides
Ready to get started?
Tell us about the job and we will get back to you with a straight answer on price and timing. Estimates are free.